Epoxy Organic Zinc Rich Primer
Product OSVX408
DESCRIPTION
Product OSVX408 Epoxy Organic Zinc Rich Primer is a
two component epoxy primer which provides both barrier and sacrificial
protection against steel corrosion. Product OSVX408 promotes
adhesion, dries rapidly, and can be either shop or field applied.
This product cannot
be shipped to CA due
to VOC regulations. .
ADVANTAGES
- Meets SSPC Paint Specification no. 20, Type II.
- Meets ASTM D 520 Type I
- Bonds tenaciously to metal.
- Promotes adhesion of subsequent coats.
Steel surfaces should be abrasive blasted to a commercial gray metal finish
as specified by the Steel Structures Painting Council SSPC SP-6. Meets ASTM D
520 Type I. All work blasted shall be coated the same day with
Product OSVX408 Zinc Rich Primer.
PHYSICAL PROPERTIES
|
Color |
Gray |
|
Tack Free Time |
60 minutes @ 72�F (22.2�C) |
|
Pot Life |
360 minutes @ 72�F (22.2�C) +/- 2� |
|
Solids |
58% by volume |
|
Solids |
88% by weight |
|
Total zinc dust by weight of solids |
90% |
|
Finish |
Flat |
|
Viscosity |
100 Krebs units |
|
VOC |
2.95 lbs / gallon |
|
Dry Temperature Resistance Without Topcoating. |
Continuous 300 degrees F
Intermittent 400 degrees F
|
SURFACE PREPARATION
Steel Surfaces:
Steel surfaces should be abrasive blasted to a commercial gray metal
finish as specified by the Steel Structures Painting Council SSPC SP-6.
All work blasted shall be coated the same day with Product OSVX408 Zinc Rich Primer.
MIXING
Stir Component "A" thoroughly before combining with Component "B".
Combine 5 parts by volume Component "A" to 1 part by volume Component
"B". Mix for not less than three (3) minutes, using slow speed drill
(300 to 600 rpm) and Epoxy.com -Mixing Paddle. When mixing has been
completed, cover mixed material tightly and allow an induction time of
not less than 45 minutes before application. Re-stir prior to
application.
APPLICATION
Product OSVX408 Epoxy may be applied by brush, roller,
or spray. Stir intermittently during application to prevent zinc
settlement. All spray equipment must employ traps to prevent water and
oil from contaminating coating. Wait a minimum of 16 hours or a maximum
of 5 days before subsequent coatings are applied. The recommended dry
film thickness of 2.5 to 3.5 mils.
COVERAGE
Product OSVX408 will cover approximately 275 SF (25.55
m2) per gallon depending upon surface texture to obtain 2.5 mils dry
film.
PACKAGING
One (1) gallon kits.
CAUTION
DANGER! FLAMMABLE! Contains xylene. Keep away from heat, sparks,
and flame. Avoid breathing vapor. Use with forced air ventilation in
confined areas. Avoid contact of resin or hardener with skin or
eyes. In case of eye contact, flush immediately with plenty of water
and consult a physician. Do not take internally.
FOR INDUSTRIAL USE ONLY. KEEP AWAY FROM CHILDREN
