Epoxy.com Product #241
Acrylic Sealer - Low VOC
DESCRIPTION
Epoxy.com Product #241 Acrylic Sealer with Low VOCs is a clear acrylic emulsion formulated to
create a clear, non-yellowing, protective coating. Epoxy.com Product #241 Acrylic
Sealer with Low VOCs provides a tough, UV, and abrasion resistant film that protects surfaces
from moisture penetration, staining, dirt, dust, wear, and provides a surface
that is easy to clean and maintain. Epoxy.com Product #241 Acrylic Sealer is an
excellent choice for both interior and exterior applications.
The excellent water, alkali, and efflorescence resistance of this product, in
combination with its exterior durability and its ability to adhere to a variety
of substrates, allow it to be used in many applications. Epoxy.com Product
#241 Acrylic Sealer with Low VOCs is designed as an effective terrazzo sealer thereby replacing
flammable acrylic sealers. Epoxy.com Product #241 Acrylic Sealer with Low VOCs can be used to
seal concrete, masonry, pavers, brick, Saltillo tiles , or any cementitious
substrate. While it is a clear-drying formulation, it will tend to impart a rich
darkening, or "wet look" quality to many substrates, especially those of a dark
or tinted nature.
ADVANTAGES
- Hot Tire Resistant
- UV Resistant
- Waterborne
- Excellent Clarity & Color Retention
- Low Maintenance Finish
- Fast Dry Time
- Excellent Abrasion & Mar Resistance
- Seals Substrate from Moisture Penetration
CONSIDERATIONS
- Substrate temperature must be a minimum of 50°F
- Substrate must be free of dirt, waxes, curing agents, and other foreign materials.
COVERAGE
200-600 Square feet per gallon per coat depending on the surface porosity and/or application Method.
APPLICATION
SURFACE PREPARATION
Surface Preparation is the most critical portion
of any successful resinous flooring system application. All substrates must be
properly prepared as outlined in Epoxy.com Surface Perparation Guide.
Epoxy.com's Technical Service Department will answer any questions. All surfaces
must be clean and free of loose debris, dirt and dust, grease, oils, curing
agents, bonding agents, and cleaning solutions. Cleaning may be accomplished by
pressure washing, mechanical sanding, scraping, chipping, or sand blasting.
Repair all cracks with the appropriate patching material for the existing
substrate.
INSTALLATION
Epoxy.com Product #803 Acrylic Sealer can be easily
applied. Apply with low pressure pump at 200-600 square feet per gallon. Can
also be brushed or rolled using a lamb's wool applicator. Coverage will vary due
to ambient temperature, surface temperature, surface porosity, and/or
application methods. Do not apply if surface temperature is below 45°F. Avoid
pooling and applications to areas that are subject to ponding water. A single
coat will seal the substrate to minimize staining while producing a "patina"
like finish. Subsequent coats will create a surface film with a higher sheen.
Care should be taken to minimize the entrapm ent of air caused by over-rolling.
Two coats are recommended for sealing applications. Thinning No thinning is required. Apply at package consistency.
CLEAN UP
Clean skin with soap and water. Tools and equipment can be cleaned with soap and water, xylene
or lacquer thinner.
TECHNICAL CHARACTERISTICS
| Weight/Gallon | 8.5± .2 |
| Drying Time | 15-30 minutes |
| Re-Coat | 1 hour. Good air movement and humidity control are
necessary for proper drying and waterborne coatings. |
| Flash Point | None (Seta Flash) |
| pH | 8.5 - 8.9 |
| Solids Weight % | 20.0% |
| Package Life | 1 year, unopened |
| VOC | 0.60 grams/liter |